Columns
I recently had some feedback from a reader who offered me three pieces of advice to pass along to those of you who have senior leaders who are as much…
Published in
Columns
Check the checklist: What has standards work done for me?
Written by Dr. Timothy Hill January 24, 2012
This is one question that lurks behind most discussions I've had about standards and standards work. Those who find standards work challenging tend to respond with, "What we've been doing…
Published in
Columns
Lean and your leaders: How to get them out of the office and to the gemba
Written by Dr. Timothy Hill November 17, 2011
A reader wrote to me and described a situation with his employer. He described his firm's adherence to Lean as something that was good on a good day and rather…
Published in
Columns
Making the case for Lean: It's more than just a toolbox
Written by Dr. Timothy Hill October 19, 2011
One question that I hear a lot is, "How do I convince my leaders to practice Lean?" I suspect that I hear this question for two reasons: 1. Their leaders…
Published in
Columns
In keeping with the spirit of this issue - the 25th anniversary of Manufacturing AUTOMATION - below is a list of the top 25 ways to make Lean a success…
Published in
Columns
Toyota has about 45 minutes worth of inventory sitting around at any given time. When I tell people this fact, they are all aghast; particularly those in the health care…
Published in
Columns
Not too long ago, I was reading an interview with Robert "Doc" Hall, Professor Emeritus at Indiana University, and a founding member of the Association for Manufacturing Excellence. In the…
Published in
Columns
Twenty-five years after the release of Masaaki Imai's classic book Kaizen, many organizations have continued to pursue Lean/kaizen. Unfortunately, many more have dropped their efforts.
Published in
Columns
I am often asked about the presentation of Lean results. "How do we report our gains?" "Where do we post our gains?" "Do I need to make my results fancy,…
Published in
Columns
A little while ago, I presented at the Second Canadian Quality Congress and had the opportunity to meet one of my mentors, Masaaki Imai. We recalled the 1988 opening of…
Published in
Columns
MA Online Resource Centre
-
Videos
-
Manufacturing Automation's Editor Reports
Get the latest industry news from our magazine's editor
-
Manufacturing Automation's Editor Reports
Featured Video
-
View Video...
A new business book, How can we make manufacturing sexy?, addresses the industry’s and the public’s role in bringing manufacturing back to Canada. The book takes a look at how…
