Manufacturing AUTOMATION

Zettlex releases position sensors for angle measurement

November 7, 2019
By Manufacturing AUTOMATION

Zettlex IncOder

Zettlex’s new position sensors, called IncOders, use non-contact, inductive technology for precision angle measurement.

Zettlex sensors use printed circuits for compact, accurate, lightweight and robust position sensors. IncOders are ideally suited to harsh environments – where potentiometers, optical or capacitive devices may prove unreliable.

IncOders have two main parts – a stator and a rotor, each shaped like a flat ring. The large bore makes it easy to accommodate through-shafts, slip-rings, optical-fibres, pipes or cables. The stator is powered and the rotor is passive. The stator contains the electronics to receive power and generate an output signal.

The output signal from the stator shows the true absolute angular position of the rotor relative to the stator without the need of any motion.

IncOder inductive angle encoders do not require compliant or special couplings and the rotor and stator can simply be screwed to the host product.

Precise mechanical mounting is not required and there are no bearings. Unlike capacitive devices, there is no need to earth the rotor or stator. Robust, hard-anodized aluminium alloy housings and monolithic constructions are used throughout.

There are no contacting, delicate or wearing parts, so there is no need for periodic replacement, service or maintenance.

Available at Electromate.

Print this page


Story continue below